- #CLOVER CONFIGURATOR GENERATE SERIAL NUMBER SERIAL NUMBERS#
- #CLOVER CONFIGURATOR GENERATE SERIAL NUMBER SERIAL NUMBER#
Click OK button to create your finished good item.ģ.
#CLOVER CONFIGURATOR GENERATE SERIAL NUMBER SERIAL NUMBER#
Under the Engineer fast tab, Formula planning section, set Production type equal to NoneĬreate a new released product as a finished good that will utilize the serial number group and component created above.Ģ. This is at Product information management | Common | Released ProductsĦ. With your new component item created highlight your item Component item.Ĥ. Click OK button to create your component item.ģ. To do this go to Product information management |Common | Released ProductsĢ. Make sure to mark Production activation to use with Production orders.Ĭreate a new released product to be used as a component.ġ. Under the Activation fast tab- Select the modules you want to activate the number group. This is at Inventory management | Setup |Dimensions | Numbers Groupģ. There may be minor variations using other data, but as long as the above settings are applied, you should see the same result.Ĭreate a new serial number group with the ‘Only for inventory transactions’ and ‘Production activation’ options enabled and the ‘On physical update’ option disabled. The final key to making this work is that on the released product, you must select the serial number group that has been set up with these parameters.įollowing are the detailed steps to set this up with the above settings on the creation of the serial number group including the creation of the component and finished good all the way through to the production order. Also note that this option is only available when the ‘Only for inventory transactions’ option is also enabled. If you do mark the ‘On physical update’ option, the serial number would still be automatically assigned, but not until the physical update takes place with the Report as finished journal. The ‘On physical update’ option would need to be disabled/unmarked.
#CLOVER CONFIGURATOR GENERATE SERIAL NUMBER SERIAL NUMBERS#
If you unmark the ‘Production activation’ option, serial numbers would not be auto generated at any point in the production process, and would need to be manually assigned. The ‘Production activation’ option would need to be enabled/marked. value, and would have a single serial regardless of the quantity specified on the transaction. If you unmark the ‘Only for inventory transaction’ option, the serial number would still be automatically assigned, but you lose the option of setting the Per qty. The ‘Only for inventory transactions’ option would need to be marked. Those options are ‘Only for inventory transactions’, ‘Production activation’, and the ‘On physical update’ option. There are three setup options on the serial number group that allow this to happen. This article describes the setup that is needed to get serial numbers auto generated prior to the report as finished on a production order.